CNC MILLING & WIRE EDM

Automation Fixture with Locating Pins

A typical set of fixture plates and clamp blocks for a robotic assembly cell, locating a workpiece repeatably through hardened pins, bushings and precision slots.

Request a Quote
Batch of machined fixture clamp blocks with locating pins and counterbores

Typical requirements

Component
Fixture plates and clamp blocks
Material
Aluminum 6082-T6; hardened tool steel pins
Process
CNC milling, slow-wire EDM, press-fit assembly
Critical features
Pin positions ±0.01 mm, flatness 0.02 mm
Finish
Hard anodize; pins ground
Inspection
CMM report per fixture

Engineering considerations

  • When identical fixtures serve parallel cells, any fixture must accept parts from any upstream station.
  • Locating pin positions define the robot’s pick position and must match between sets.
  • Large aluminum plates tend to bow when pockets are machined from one side.
  • Wear surfaces should be replaceable without re-machining the plate.

Typical manufacturing route

01

Datum design

All pin and bushing positions are referenced to one datum frame shared by every fixture in the set.

02

Milling

Plates are machined from both sides with stress relief between roughing and finishing to hold flatness.

03

Wire EDM

Hardened locating slots and inserts are cut on slow-wire EDM for accurate, burr-free profiles.

04

Assembly

Plates are hard anodized with the pin and bushing holes masked, and those holes are checked after coating. Pins and bushings are then pressed in and each fixture is marked with a serial number for traceability.

Typical inspection plan

  • Each assembled fixture measured on CMM: pin positions, slot widths and plate flatness.
  • Fixture-to-fixture comparison report confirming interchangeability across the set.
  • Hardness of pins and inserts verified after heat treatment.

Applying this to your part

The actual route, tolerances, inspection scope and records are agreed for each drawing during quotation.

PROJECT INQUIRY

Request a quotation for a similar component

Send the drawing, material, quantity and the features that control assembly. An engineer replies within one business day; NDAs are signed on request.

Request a Quote
WhatsApp